OB-101-16熱電偶膠 美國omega高溫固化膠

Thermally Conductive Epoxies and Thermally Conductive Grease
OB-100, OB-200 Epoxy Series, & OT-201 Thermal Grease
Thermally Conductive Epoxies
OB-100, OB-200 Epoxy Series, & OT-201 Thermal Grease:Thermally Conductive Epoxies and Thermally Conductive Grease
OB-100-1/4
Thermally Conductive
Electrical Insulator
Resist Oils, Solvents, Most Acids
OMEGABOND® 100 Two Part Epoxy: Low Thermal Conductivity. Sets at Room Temp. Good to 130°C (265°F)
OMEGABOND® 101Two Part Epoxy: High Thermal Conductivity. Sets at Room Temp. Good to 105°C(221°F)
OMEGABOND® 200 Two Part Epoxy: Very High Thermal Conductivity. Sets in 2 Hrs at 205°C(400°F). Good to 260°C(500°F)
OMEGATHERM® 201Silicone Paste: Extremely High Thermal Conductivity. Non-Adhesive. Does not Harden. Good from -40 to 200°C(-40 to 392°F
OMEGABOND® epoxy and OMEGATHERM® thermal conducting paste are easy to use epoxies and silicone products. They are specially formulated for permanent bonding of thermocouples, thin film RTDs, t
 

hermistors and other temperature sensors, to most surfaces–metals, ceramics, glass, plastics, paper products. OMEGABOND® and OMEGATHERM® products are compounded and packaged for convenient, easy mixing a
 

nd application. Each formulation exhibits important characteristics necessary for accurate, fast, reliable temperature measurement. These are: good adhesion and strength, high temperature rating, high thermal conduction, high e
 

lectric insulation, thixotropic consistency, fast cure, and easy application.
“Twin pak” packaging is supplied to ensure the user with accurate proportioning of resin and catalyst, as well as to provide a clean, fast means of mixing. The “Twin Pak” is a flexible, transparent plastic pouch, separated into two is
 

olated compartments by means of a removable external divider. In one compartment is the resin, the other the pre-measured catalyst. To use, remove the divider, mix the two components by kneading the pouch, then snip off a corner to
 

dispense. Each “Twin Pak” comes with an instruction sheet, enclosed in a clear, heat-sealed plastic envelope.
Please note that once mixed, the OB-100, OB-101 and OB-200 epoxies have the following "Working Times" (also referred to as "Pot Life"):
OB-100: Less Than 8 Minutes at Room Temperature
OB-101: Approximay 30 Minutes at Room Temperature
OB-200: Approximay 24 Hours at Room Temperature

產(chǎn)品型號/產(chǎn)品描述
OB-100-1/4 1/4 oz., fast room-temperature, two part epoxy
OB-100-1 Four 1/4 oz., fast room-temperature, two part epoxy
OB-101-1/2 1/2 oz., highly conductive room-temperature, two part epoxy
OB-101-2 2 oz., highly conductive room-temperature, two part epoxy
OB-101-16 1 lb., highly conductive room-temperature, two part epoxy
OB-200-2 2 oz., highly conductive two part epoxy to 500°F
OB-200-16 1 lb., highly conductive two part epoxy to 500°F
OT-201-1/2 1/2 oz., thermally conductive silicone paste
OT-201-2 2 oz., thermally conductive silicone paste
OT-201-16 1 lb., thermally conductive silicone paste
OT-201-32 Two 1 lb.pkgs, thermally conductive silicone paste

 OB-101-16熱電偶膠 美國omega高溫固化膠